An end-grain cutting board has the benefits of being both attractive and easy on your knives. This cutting board construction creates a distinctive looking checkerboard pattern. An end-grain board also has a very fibrous cutting surface, so a knife’s edge is likely to sink into the wood fibers while you are cutting.
Also question is, are end grains worth it?
All this being said, both boards will sustain damage through use. End grain will however wear much better which will leave you with a flatter cutting surface for longer. This will increase the edge retention of your knives, and make them cut more efficiently.
Moreover, can you make cutting boards out of pine?
The best way to make a cutting board with pine is to use the end grain for the cutting surface to minimize cutting marks and to increase strength. Pine is a good and cheap alternative to use as wood for a cutting board, but it will be inferior in performance compared to hardwoods like maple, walnut, and teak.
Can you put an end grain cutting board through a planer?
What Is the Average Lifespan of a Wood Board? When properly taken care of, the premium wooden cutting board can last between five and ten years. One of the main reasons why boards are replaced is because they become worn, warped, or miscolored. You can circumvent most of these with regular maintenance.
How thick should end grain cutting board be? Keep end grain cutting board thickness between 2″ and 2 ½” inches. Making the cutting board thinner than this might cause it to warp easily and crack. If it is made thicker than 2 ½ inches, the cutting board will become too heavy for everyday use and for moving it around.
In terms of thickness, professional grade rubber boards are thinner and lighter, typically between ½- to 1-inch thick, while a well-crafted wooden board should be anywhere from 1 ¼- to 2-inches thick. Wessel says that for an end-grain cutting board he advocates for at least 2 inches of thickness.
we would avoid open-pored woods like ash and red oak, which will be harder to keep clean from food stains. Pine might impart a resinous taste, and it’s soft so will show cutting scars from knives more easily than a harder wood like maple.
Common hardwoods used for end grain cutting boards include walnut, hard maple, birch, cherry and oak. Whatever wood you choose, have it cut between 2 1/2 and 3 1/2 inches thick to deter splitting and warping.
This block construction makes the butcher block very strong and durable. During cutting and chopping, the end grain wood fibers absorb the impact of the knife blade so the block is resistant to nicks and gouges.