How do you strap down a hot water heater?

>> Click to read more <<

Also know, can you enclose a water heater?

In most instances, a home’s water heater is placed in the basement. … You can enclose the water heater by building a wall around it and constructing a utility closet.

Simply so, do tankless water heaters need seismic straps? All water heaters.

All storage type (tanks) heaters require strapping – gas or electric. Tankless type heaters need not be strapped.

Additionally, do tankless water heaters require seismic straps?

The code specifically requires that water heaters be strapped or anchored to resist horizontal displacement from earthquake motion. Strapping must take place in the upper 1/3 and lower 1/3 of a tank-type water heater (not a tankless water heater).

Does FHA require water heater straps?

What does FHA say about water heaters? … Lastly, regardless of whether the water heater is gas or electric, earthquake straps are required in California on standard water heaters. Ultimately since the gas water heater was on the ground during an FHA appraisal inspection, it had to be raised to meet current code.

Does Utah require double strapped water heaters?

As a minimum requirement,

Index Utah Code
Title 15A State Construction and Fire Codes Act

How do you put a earthquake strap on a hot water heater?

How do you secure a free standing water heater?

Wrap the heavy-gauge metal strapping 1-1/2 times around the tank. Start by placing the strapping at the back of the tank. Bring it to the front and then take it back to the wall. Secure this strapping to the wall studs or the wood block using several 1/4-inch x 3-inch or longer lag screws with oversized washers.

How do you strap a water heater in the middle of a room?

Secure your water heater.

  1. There should be very little space between the water heater and the wall. …
  2. Wrap the heavy-gauge metal strapping 1½ times around the tank. …
  3. Secure this strapping to the wall studs or the wood block using several 1/4″ x 3″ or longer lag screws with oversized washers.

How do you strap a water heater that’s not against the wall?

How much clearance do you need around a water heater?

A clearance area of 12 inches is required on all sides of a hot water heater. A certain amount of airflow is also required for proper combustion and ventilation. The building code states that proper airflow for these functions must be provided according to the manufacturer’s specifications for the unit being installed.

What is code for strapping a water heater?

California Plumbing Code Section 507.2 requires that all water heaters shall be supported and strapped to prevent movement during an earthquake. Two metal straps, not less than 22 gauge, nor less than 5/8-inch wide shall be used.

What states require water heater straps?

In addition to California and Alaska, areas of Nevada, Idaho, Wyoming, Montana, Oregon, Washington and Hawaii also fall under the Uniform Codes’ seismic zones 3 and 4, where water heaters are specifically required to be anchored.

Where do the straps go on a water heater?

All water heaters must be strapped in at least two locations; the upper one-third of the unit and the lower one-third. The lower strap must be a minimum of 4″ above the water heater control unit.

Why do water heaters need to be strapped?

Answer: Since 1982, the Uniform Plumbing Code has mandated seismic safety straps for most water heaters. The purpose of this requirement is to prevent fire, explosion or water damage if a water heater should topple during an earthquake.

Leave a Comment