There are more than 50 brands of residential tank type electric water heaters in the U.S., most thermostats are interchangeable, however, read the product description carefully. If you must replace a thermostat its always a good idea to replace both thermostats at the same time.
Then, can you fix a water heater thermostat?
Also know, do I have to drain my water heater to change the thermostat?
Always disconnect the power or shut off the breaker before doing any work on a water heater. To change thermostats, you will need to remove the access panel and safety cover (do this for both upper and lower access panels on dual element units). … Remove the wires from the thermostat.
How do I change my electric thermostat?
How do I check if my cylinder thermostat is working?
How do I know if my electric water heater thermostat is bad?
If you turn the hot water tap and cold water runs out, then the upper thermostat is damaged. But if the water is hot that becomes later becomes cold, then you have a damaged lower thermostat.
How do I reset my water heater thermostat?
Somewhere on your electric water heater, you’ll find a reset button. It’s usually red and often located near the thermostat. It may also be hidden behind a removable metal panel on the unit—and then behind some insulation. Once you find the button, push and release it.
How do I test my thermostat?
How do you change a heater thermostat?
How do you test a thermostat on a electric water heater?
How many thermostats does a electric water heater have?
How much does it cost to replace a water heater thermostat?
The average thermostat replacement cost is between $100 and $300. Most other repairs are equally affordable. There are two main types: gas and electric. A gas unit works by way of a gas flame while an electric one works using electric elements, or coils.
Why do electric hot water heaters have two thermostats?
An electric storage-tank-style water heater has two thermostats because it has two heating elements. The thermostats are designed so only one element is active at a time. The reason only one element is active at a time is because it allows for smaller wire sizes and lower amperage demand when in operation.