Your water heater requires air to keep the pilot light burning. Otherwise, the flame goes out. Ensure that the water heater is not surrounded by clutter, lint, or debris to increase the amount of combustible air. Keep the surrounding area as clean as possible.
Similarly, does an Atwood RV Water Heater have a thermocouple?
While there is not a gas line, there is a thermocouple you can use for the Atwood RV Water Heater # AT96110 (which is the G6A-7).
Beside this, how do I reset my Atwood water heater?
Find the reset button near the heating element. The reset button is red and is probably protruding out if it requires resetting. Push the reset button in with your finger until it clicks into place. The top of the button remains flush with the side of the water heater.
How do I test my Atwood water heater thermostat?
How do you light the pilot light on a Atwood RV water heater?
How do you reset an RV water heater?
How do you test a thermocouple on a camper water heater?
What do thermocouples do?
Thermocouples are sensors used to measure temperature. It is a device used inside a gas furnace in Kansas, to assist the pilot light in keeping your furnace running and safe. It works rather like a fail-safe to keep unburned gas from accumulating and burning, exploding or causing another type of health risk.
What do you do if your hot water heater pilot light won’t stay lit?
What would cause a pilot light to not stay lit?
The Buildup of Dirt or Debris Around The Pilot Light – Over the years it’s easy for dust, debris, and dirt to build up on the inside of the intake valve where the pilot light resides. This makes it difficult for the flame to breath and as a result causes the pilot light to go out suddenly.
Why is my Atwood Hot water heater not working?
One of the most common problems with Atwood RV water heater is a pilot outage. This can happen if you have a weak gas control magnet or if the thermocouple needs to be replaced. For poor pilot flame, you would need to replace the orifice. If it is not too old hen you can try cleaning the orifice and see how it goes.