Your thermocouple senses when your pilot light is burning. … If it senses that your water heater pilot light keeps going out, the thermocouple will shift off the gas supply to the heater. Over time, thermocouples can malfunction, accumulate dust buildup, or the device can get bent away from the pilot light’s flame.
Also question is, can you clean a thermocouple?
Yes, you can clean a thermocouple, but the task must be done with a light touch. Remove the thermocouple from the process assembly, using a steel wool or emery cloth, lightly clean the tip removing any build up.
Subsequently, how do you bypass a thermocouple?
To bypass the thermocouple:
- Move the tilts switch wire aside.
- Remove your thermocouple from the heater using an 8mm wrench.
- Pull the valve housing aside using your 13mm socket wrench. …
- Remove the valve using your pliers. …
- Put your thermocouple back into position.
How do you test a thermocouple?
How long should a water heater thermocouple last?
In effect, new thermocouples were installed into contaminated tubes, causing the degradation of the sensors and generating greater than a 100°F shift in accuracy. In this scenario, thermocouple life, which should have been close to one year, was shortened to within a week.
How much does it cost to replace a water heater thermocouple?
Thermocouple – $20 to $150
The thermocouple is an apparatus that senses whether the pilot light is lit and triggers the gas control valve. Repairs typically cost about $150 to have it done professionally, though a new thermocouple itself only costs about $20 on average.
How much is a thermocouple?
1 cause of pilot lights that won’t stay lit is a worn-out thermocouple. It’s easy to replace and a new one costs $5 to $10. Rather than trying to unfasten the thermocouple inside the water heater’s burning chamber, it’s easier to remove the whole burner and thermocouple assembly.
Should the water heater be on pilot or on?
On gas water heaters, the pilot light makes sure that there’s always flame available when the burner needs to kick in and heat water. If you run out of gas, install a new water heater or have to shut it down for some reason, lighting the pilot is the first step to turn on a water heater.
What do you do if your water heater pilot light won’t stay lit?
Why does my gas heater keep going out?
If your furnace keeps shutting off, it could be due to low airflow. There are several indirect issues that cause low airflow. Dirty Air Filters. If you don’t change your air filters often enough, the filters will become dirty and clogged, which means the heat exchanger retains heat and eventually causes it to overheat.
Why does my pilot light go out when I release the pilot light knob?
The most likely of those is that the thermocouple needs to be replaced. The button you press to light the pilot bypasses the thermocouple. When you release the button, the thermocouple ensures that unburned gas doesn’t get released by shutting off the gas when it’s not heated by the burning pilot light.
Why my gas water heater keeps turning off?
If your gas water heater keeps turning off, the problem most likely lies with the thermocouple. This vital component detects when the pilot light is lit and then allows gas to flow to the burner. A faulty thermocouple will shut off gas to the burner as well as the pilot.