ANSWER: Hi the two switches in the kitchen of your RV are for your RV’s Hot Water Heater which can be operated either by propane or 120 volt electric. When you are not connected to electric and need hot water you would turn on the switch with the flame on it to run the hot water heater on Propane.
Consequently, how do I change the switch on my RV water heater?
Considering this, how do I reset my suburban water heater?
The left-hand button is the electric circuit reset and the right- hand is the LP reset. If both power switches are ON, but the electric element is not heating the water, press both reset buttons on the back of the water heater.
How do I switch my RV hot water heater from gas to electric?
How to Convert a Gas RV Water Heater to Electric
- Shut off the water pump or the water supply to the RV. …
- Wrap pipe tape on the threads. …
- Run a 110 service line to the hot water tank. …
- Locate the hot water tank’s tin cover and remove it. …
- Attach the hot wire from the thermostat to one post on the electric heater element.
How do I switch my RV water heater from gas to electric?
How do I turn on the hot water in my RV?
Open a hot tap and let the water run for a few seconds. Doing this will ensure you have water in your tank to heat. Next, you’ll want to switch the water heater on. As mentioned before, you can choose to use both the propane and electric options together if you happen to have a heater with both.
How do you turn on the water heater on a suburban RV?
How long does it take a 6 gallon RV water heater to heat up?
If you have a 6 gallon water heater, expect it to heat at 17.8 gallons per hour and take 20 minutes to heat up. If you have a 10 gallon tank, it can take about 33 minutes to fully heat up.
Where Is My RV water heater switch?
Locate your hot water heater access panel, typically on the outside of your RV, and remove it. Find the RV water heater on and off switch on the panel. Typically, it’s located on the bottom left-hand side (see image above). Flip the switch to the on position.