Re-install the cassette tape back into the machine. Push down on top of the cassette; ensure that it is seated firmly in the tape compartment and close the cover. … Turn on the machine and try printing a label.
Considering this, how do I change the settings on my Brother label maker?
How do I change the length of the label?
- Press the [Label] key ( / ). The current settings are displayed.
- Select the “Length” attribute using the or key, and then set a value using the or. key.
- Press the [OK] key ( ) or [Enter] key ( / ) to apply the settings.
Also to know is, how do I change the tape on my P-Touch label maker? FAQs & Troubleshooting
- Check that the P-touch labeler is turned off.
- Open the cassette cover as shown by the arrow in the illustration while pressing the part marked ” <<".
- Insert a tape cassette.
- If the ink ribbon is loose, use your finger to wind the toothed wheel in the direction of the arrow on the cassette.
Besides, how do I reset my brother label maker?
Reset the label machine
- Turn off the label machine.
- Hold down the Shift key and the letter R key.
- While holding down the keys, press the Power key once to turn on the label machine.
- Release the keys. “English” should be displayed. …
- “inch” will be displayed and press the Enter key.
How do I setup my P-Touch label maker?
Setting up the P-touch labeler
- Setting the tape cassette. Open the cassette cover. Insert the tape cassette. Close the cassette cover. …
- Connecting the power supply. Power the P-touch labeler using the AC adapter or batteries. Using the AC adapter. Plug in the P-touch labeler using the AC adapter.
How do you adjust the tape on a Brother P Touch?
To change the length of the label,
- Press the [Label] key ( / ).
- Press the [Cursor] key ( ) until [Label Length] is displayed.
- Press the [OK] key ( ).
- Press the [Cursor] key ( ) until your desired length is displayed. ( AUTO or 30 – 300 mm / 1.2″ – 12.0″) …
- Press the [OK] key ( ) to apply the setting.
How do you load p-touch tape?
How do you not waste tape on Brother P-Touch label maker?
How do I eliminate the margin from the start or end of my label when printing?
- Press the [Label] key ( / ).
- Press the arrow key or. to select “Margin”.
- Press the arrow key or. to select “Narrow”.
- Press the [OK] key ( ) or [Enter] key ( / ). This eliminates the margin at the end of the tape after printing as shown below:
How do you put a cassette in a Brother label maker?
What does no cassette mean?
The machine does not recognize the tape cassette installed in the machine. Open the tape compartment cover and remove the tape cassette from the machine. … Check the label on cassette tape, only TZ tapes can be used with this machine; TZe and HG tapes are not compatible with this machine.