California Plumbing Code Section 507.2 requires that all water heaters shall be supported and strapped to prevent movement during an earthquake. Two metal straps, not less than 22 gauge, nor less than 5/8-inch wide shall be used.
Also to know is, can you enclose a water heater?
In most instances, a home’s water heater is placed in the basement. … You can enclose the water heater by building a wall around it and constructing a utility closet.
Subsequently, do water heaters need to be strapped in Washington?
Water heaters shall be anchored or strapped to resist horizontal displacement due to earthquake motion. Strappings shall be at points within the upper one-third and lower one-third of its vertical dimensions.
Does a water heater need to be strapped?
(1) All water heaters must be strapped, whether gas or electric. (2) Two straps are needed, one in the upper one-third and one in the lower one-third of the fixture. (3) Straps may consist of either plumber’s tape (at least 24 gauge) or half-inch-diameter metal conduit.
Does FHA require water heater straps?
Both the appraiser and the loan officer swear FHA requires that all water heaters be seismically strapped.
Does South Carolina require water heater straps?
In Seismic Design Categories D0, D1 and D2 and townhouses in Seismic Design Category C, water heaters shall be anchored or strapped in the upper one-third and in the lower one-third of the appliance to resist a horizontal force equal to one-third of the operating weight of the water heater, acting in any horizontal …
Does Utah require double strapped water heaters?
As a minimum requirement,
| Index | Utah Code |
|---|---|
| Title 15A | State Construction and Fire Codes Act |
How do you secure a hot water heater?
Securing your hot water tank
- There should be very little space between the water heater and the wall. …
- Wrap the heavy-gauge metal strapping 1½ times around the tank. …
- Secure this strapping to the wall studs or the wood block using several 1/4″ x 3″ or longer lag screws with oversized washers.
How do you strap a free standing water heater?
Wrap the heavy-gauge metal strapping 1-1/2 times around the tank. Start by placing the strapping at the back of the tank. Bring it to the front and then take it back to the wall. Secure this strapping to the wall studs or the wood block using several 1/4-inch x 3-inch or longer lag screws with oversized washers.
How do you strap a water heater?
How many straps are required on a 75 gallon water heater?
How much clearance do you need around a water heater?
Water heaters must be surrounded by a certain amount of clearance, or air space, to function properly and safely. A clearance area of 12 inches is required on all sides of a hot water heater. A certain amount of airflow is also required for proper combustion and ventilation.
What states require water heater straps?
In addition to California and Alaska, areas of Nevada, Idaho, Wyoming, Montana, Oregon, Washington and Hawaii also fall under the Uniform Codes’ seismic zones 3 and 4, where water heaters are specifically required to be anchored.