California Plumbing Code Section 507.2 requires that all water heaters shall be supported and strapped to prevent movement during an earthquake. Two metal straps, not less than 22 gauge, nor less than 5/8-inch wide shall be used.
In this regard, are water heater straps required in Oregon?
Installation: Portland plumbing regulations require that all homeowners and Portland plumbers follow specific water heater installation steps. For instance, “water heaters installed within 12 inches above the floor are required to be strapped between the top one third and top one-half of the tank”.
Regarding this, do electric water heaters need straps?
(1) All water heaters must be strapped, whether gas or electric. (2) Two straps are needed, one in the upper one-third and one in the lower one-third of the fixture. (3) Straps may consist of either plumber’s tape (at least 24 gauge) or half-inch-diameter metal conduit.
Does FHA require water heater straps?
What does FHA say about water heaters? … Lastly, regardless of whether the water heater is gas or electric, earthquake straps are required in California on standard water heaters. Ultimately since the gas water heater was on the ground during an FHA appraisal inspection, it had to be raised to meet current code.
How do you brace a water heater?
Secure your water heater.
- There should be very little space between the water heater and the wall. …
- Wrap the heavy-gauge metal strapping 1½ times around the tank. …
- Secure this strapping to the wall studs or the wood block using several 1/4″ x 3″ or longer lag screws with oversized washers.
How do you lift a heavy water heater?
How do you put a earthquake strap on a hot water heater?
How do you secure a water heater to the wall?
How do you strap a water heater in a corner?
How heavy is a full water heater?
Tank-style water heaters weigh an average of 150 pounds empty, but it varies by size. On average, tank-style water heaters weigh 2.6 pounds per gallon of capacity. Tankless water heats are significantly lighter, averaging 27 pounds. And, under the sink water heaters weigh an average of 32 pounds.
How much does a 40 gallon hot water heater weigh empty?
Is it OK to transport a new water heater on its side?
When moving, replacing, or installing hot water heaters, transport them with care to avoid damage. … If the hot water heater is not properly moved while in a horizontal position, the metal casing could become damaged or the glass lining could crack.
What is earthquake strap?
Earthquake straps are brackets that attach bookcases to walls and keep them from tipping or rocking when heavy books or items are stored on them.
What states require water heater straps?
In addition to California and Alaska, areas of Nevada, Idaho, Wyoming, Montana, Oregon, Washington and Hawaii also fall under the Uniform Codes’ seismic zones 3 and 4, where water heaters are specifically required to be anchored.