What is a pilot tube on a water heater?

A water heater pilot orifice controls the flow of gas to the pilot. Gas. orifices are engineered to strict tolerances. A tiny amount of debris. will interfere with the operation of the pilot light.

>> Click to read more <<

Consequently, how do I know if my pilot light is out on my water heater?

When a water heater pilot light goes out, it usually means that a natural change in gas pressure extinguished the flame. The main sign that a pilot light is out is one that everyone dreads: The water won’t get hot.

Also to know is, how do you clean a clogged pilot light? How to Clean a Pilot Light
  1. Cut off the gas to your furnace. …
  2. Remove the pilot light and thermocouple assembly. …
  3. Use your pliers or wrench to remove the pilot light and thermocouple from the bracket.
  4. Using the wire brush, brush away the carbon buildup and soot from both components.

Also, how do you clean a water heater pilot?

How do you fix a pilot light on a gas heater?

Gas Heater Pilot Light Troubleshooting

  1. Check the Thermocouple. If your pilot light won’t stay alight, it might be the thermocouple. …
  2. Adjust an Irregular Flame. If your pilot light is flickering and faint, you might need to adjust the flame. …
  3. Check the Gas Levels. …
  4. Check for a Corroded Pilot Tip. …
  5. Regulate any Draft.

How do you install a pilot tube on a water heater?

How do you unclog a pilot tube?

You can clear the pilot orifice with a piece of wire or a wire brush, and it isn’t difficult to access.

  1. Remove the cover plate at the bottom of the water heater. …
  2. Turn the gas control to the “Off” position. …
  3. Locate the pilot tube. …
  4. Clean the pilot hole by brushing it with a stiff wire brush.

How much does it cost to replace pilot light on water heater?

Hot water heater repair cost

Service Average cost to repair
Pilot light replacement $50 – $200
Pressure relief valve replacement $50 – $300
Thermocouple replacement $100 – $325
Thermostat replacement $100 – $350

What causes water heater pilot to go out?

A dirty thermocouple is the most common cause of malfunctioning water heater pilot light. Because the tip of the thermocouple is exposed to a direct flame, carbon can build up and cause the flame to malfunction or go out.

What does a pilot Assembly do?

A pilot light is a small flame that is kept lit in certain gas-fired appliances like your furnace, water heater, and gas fireplace. When you turn on your appliance, gas is released to the main burner and the pilot light ignites that gas to turn on your appliance and provide heat.

What size is a natural gas pilot orifice?

approximately 0.014 to 0.026

Where is the orifice on a gas water heater?

The pilot orifice is located at the end of the pilot supply line. This is the orifice up close. Remove the burner from the water heater. Turn the burner upside down and remove.

Where is the pilot orifice located?

Where is the pilot tube on a hot water heater?

| The pilot is located near the bottom of the unit. You cannot see the pilot directly from an outside view, but, you may be able to see the silver pilot tube line and copper thermocouple leading down from the gas valve inside the manifold door assembly.

Leave a Comment