The recommended blade for cutting the finished board products is the Bosch 10″ 80 tooth carbide blade or with a hand-held circular saw, a 100 tooth 5-1/2″ blade (iffy as results will show, but may be good enough).
Also, can you cut melamine with a hand saw?
Yup, even with a power saw, masking the cut line with tape (and cutting through the tape) is the way to go. For melamine, plywood, and anything else made of compressed or brittle materials. how big of a shelf? You can generally use and hand tools to replace a power tool.
Also question is, do you need a special blade to cut melamine?
How can I cut laminate without chipping?
To cut through laminate countertops, you can use a hand saw, but a circular saw makes the job much quicker. Because a circular saw can produce jagged edges and chip the laminate, your best bet is to lay the laminate face-side down and cut from the back to the front.
How do you cut a MDF with a circular saw?
Cut through the marked area using your circular saw.
Line up the front of your circular saw with the beginning of your marked line. Then, turn the saw on and gently push it through your MDF piece. Do your best to hold the saw steady, and make sure your cutting speed is slow and consistent.
How do you cut a melamine with a hand held circular saw?
How do you cut a melamine with a router?
How do you cut laminate shelves with a circular saw?
How to Cut Laminate Shelving with a Circular Saw
- Step 1: Measure & Score. Measure and draw out your cut line, and then score the laminate on both sides of the cut line using a utility knife. …
- Step 2: Adjust Your Circular Saw & Make a Scoring Cut. …
- Step 3: Make the Final Cut.
How do you cut laminate shelves with a hand saw?
How do you cut laminate shelves without chipping?
cut laminate properly for smooth edge
A common problem with cutting laminate is a rough, chipped edge, which is usually caused by a dull saw blade or the use of a saber saw. Using a sharp, carbide-tipped blade (preferably on a table saw) is the best bet for a smooth edge.
How do you cut MDF cleanly?
A jigsaw cuts MDF as easily as it cuts plywood, although you should keep in mind that the more teeth the blade has, the less chance there is of chipping the material around the edges of the cut. Hence a steel-cutting blade, while cutting more slowly, will keep the edges intact in a sensitive cut.
How do you cut melamine without chipping a hand saw?
To cut melamine or laminate boards without chipping, your saw must be equipped with a double-sided laminate / melamine blade. These blades are specially designed for cutting and at the same time minimize chipping. Before making your cuts, get your table sawed as best you can.
How many teeth do I need to cut laminate?
Diamond-tipped blades that are made for laminate and fiber cement usually have a low number of teeth to reduce the dust produced by cutting cement. However, typical circular and miter saw blades that are used for laminate will have 80 to 100 teeth for fine, precision cutting.
What blade do you use to cut melamine?
How To: Get Clean, Chip-Free Cuts in Melamine and Veneer
- First, measure your cut line and use a straight edge, utility knife, or box cutter to lightly score along the line on both sides of the board. …
- Next, set up your table saw or circular saw blade to cut 1/4″ into the material.