The thermocouple can do this because, in its probe, it contains two different metals, and a voltage is generated when one of them is heated. This is the result of a phenomenon known as the Seebeck Effect. Nothing lasts forever, and when the thermocouple wears out, the pilot won’t stay lit and your appliance won’t work.
Furthermore, can a thermocouple be cleaned?
Yes, you can clean a thermocouple, but the task must be done with a light touch. Remove the thermocouple from the process assembly, using a steel wool or emery cloth, lightly clean the tip removing any build up.
Keeping this in consideration, can you bypass a thermocouple on a water heater?
Realistically, you have just disabled the thermocouple, but you can also reach in and unclip it from its holding bracket where it meets the pilot light. In most cases it will be held on with a gravity clip, but some are held on with a screw that must be removed with a small screwdriver.
Do Thermopiles go bad?
Like the other component parts in your furnace, the thermocouple can wear down over time, producing lower voltage than it should when heated. And the worst part is that you can have a bad thermocouple without even knowing. Therefore, inspecting and testing your thermocouple should be part of your furnace maintenance.
How do I know if my thermocouple is bad on my water heater?
If the pilot lights but the flame goes out as soon as you release the button after holding it for 60 seconds, then the thermocouple is bad. It’s possible to replace the thermocouple without removing the burner assembly, and many repair people do this.
How do you clean a thermocouple on a gas water heater?
Clean the thermocouple – using the emery cloth sandpaper, sand the ends of the thermocouple and then give it a finishing touch with the lint-free cloth. Hopefully, you can get to the ends of the thermocouple without having to detach it from the assembly, but you may have to do that.
How do you test a thermocouple on a gas water heater?
How do you troubleshoot a thermocouple?
Select the ohms or resistance option on your multimeter. Place one test lead on the side of the thermocouple and the other to the end that screws into the gas valve. If the thermocouple has proper continuity, a small resistance reading should be visible on the multimeter.
How long should a hot water heater thermocouple last?
In effect, new thermocouples were installed into contaminated tubes, causing the degradation of the sensors and generating greater than a 100°F shift in accuracy. In this scenario, thermocouple life, which should have been close to one year, was shortened to within a week.
How long should a thermocouple last?
The fireplace has thermocouples and switches. The thermocouples should last for a long time. According to experts, a four-year check cycle is all that is needed.
How much is a water heater thermocouple?
Thermocouple – $20 to $150
The thermocouple is an apparatus that senses whether the pilot light is lit and triggers the gas control valve. Repairs typically cost about $150 to have it done professionally, though a new thermocouple itself only costs about $20 on average.
What causes a thermocouple to malfunction?
METAL FATIGUE
Changes in temperature can cause regular expansion and contraction in metal, which will cause thermocouples to weaken over time. After enough time, metal fatigue can cause a thermocouple to break. … If thermocouples start to give out unusual readings, it may be suffering from metal fatigue.