Double strap – The latest code requires all water heaters to be strapped in two areas. Some pre-manufactured kits have straps that wrap fully around the water heater, while others go from one side to the other – 180 degrees.
Besides, can I install my own water heater in Texas?
A plumbing permit is required for a water heating installation. Texas requires a plumbing permit for water heater replacements. The permit requires a licensed plumbing professional to install the water heater in compliance with state and local plumbing codes.
One may also ask, does a water heater need two straps?
(1) All water heaters must be strapped, whether gas or electric. (2) Two straps are needed, one in the upper one-third and one in the lower one-third of the fixture. (3) Straps may consist of either plumber’s tape (at least 24 gauge) or half-inch-diameter metal conduit.
Does my water heater need straps?
The State of California requires that all water heaters must be strapped to resist motion during an earthquake. This may be accomplished by installing an over the counter “water heater restraint” kit approved by the Office of State Architect (O.S.A.).
How do you strap a free standing water heater?
Wrap the heavy-gauge metal strapping 1-1/2 times around the tank. Start by placing the strapping at the back of the tank. Bring it to the front and then take it back to the wall. Secure this strapping to the wall studs or the wood block using several 1/4-inch x 3-inch or longer lag screws with oversized washers.
What states is require hot water heater straps?
In addition to California and Alaska, areas of Nevada, Idaho, Wyoming, Montana, Oregon, Washington and Hawaii also fall under the Uniform Codes’ seismic zones 3 and 4, where water heaters are specifically required to be anchored.
What states require earthquake straps?
Section 510.5 of the Uniform Plumbing Code requires that earthquake straps be installed in seismic zones 3 and 4. California, Oregon, and Washington are all located in either seismic zones 3 or 4.